Assessing a Noise Reduction Method for a Low-Noise Amplifier

نوع مقاله : علمی-پژوهشی

نویسندگان

Department of Electrical Engineering, Islamic Azad University, Arak Branch, Arak, Iran

چکیده

With regards to wireless receiver systems, the effects of noise from all the following phases can be reduced using the gain of the low-noise amplifier (LNA). Therefore, boosting the specified signal power without adding a lot of noise and distortion will be necessary for the signal to be retrievable in the later phases or stages of the system. The proposed method in this study for noise reduction is based on the combination of two techniques: reversed- phase noise signal and non-reversed phase signal. The theoretical model for noise cancellation is presented along with the equations for the overall noise value, which are derived based on a two-port model. The circuit design is implemented using the  technology on a Cadence Spectre RF tool. The current study also implemented a CMOS UWB LNA configuration with inter-stage matching as well as shunt-series inductive peaking. This design uses inductive source degeneration cascode technology along with an inter-stage matching network. Moreover, to boost impedance matching and power gain, a Chebyshev band pass filter is placed at the input while a shunt-series inductive peaking is placed at the output.

کلیدواژه‌ها


عنوان مقاله [English]

Assessing a Noise Reduction Method for a Low-Noise Amplifier

نویسندگان [English]

  • P. Donyaran
  • B. Heidari
Department of Electrical Engineering, Islamic Azad University, Arak Branch, Arak, Iran
چکیده [English]

With regards to wireless receiver systems, the effects of noise from all the following phases can be reduced using the gain of the low-noise amplifier (LNA). Therefore, boosting the specified signal power without adding a lot of noise and distortion will be necessary for the signal to be retrievable in the later phases or stages of the system. The proposed method in this study for noise reduction is based on the combination of two techniques: reversed- phase noise signal and non-reversed phase signal. The theoretical model for noise cancellation is presented along with the equations for the overall noise value, which are derived based on a two-port model. The circuit design is implemented using the  technology on a Cadence Spectre RF tool. The current study also implemented a CMOS UWB LNA configuration with inter-stage matching as well as shunt-series inductive peaking. This design uses inductive source degeneration cascode technology along with an inter-stage matching network. Moreover, to boost impedance matching and power gain, a Chebyshev band pass filter is placed at the input while a shunt-series inductive peaking is placed at the output.

کلیدواژه‌ها [English]

  • Noise
  • CG UWB LNA
  • CMOS RF technology
[1] D.K. Shaffer, T.H. Lee, “A 1.5 V, 1.5 GHz CMOS low noise amplifier”, IEEE Journal Solod- State Circuits, vol. 32, pp. 745-759, 1997.
[2] J. Long, N. Badr, R. Weber, “A 2.4 GHz sub-1 dB CMOS low noise amplifier with on-chip interstage inductor and parallel intrinsic capacitor”, In Proc. IEEE radio Wireless Conf., Aug. 2002, pp. 165-168.
[3] Ch. Xin, E. Sanchez-Sinencio, “A GSM LNA Using Mutual-Coupled Degeneration”, IEEE Microwave and Wireless Components Letters, vol. 15, no. 2, 2005.
[4] P. Heydari, “Design and analysis of a performance-optimized CMOS UWB distributed LNA”, IEEE Journal of Solid-State Circuits, vol. 42, no. 9, pp. 1892-1904, 2007.
[5] A. Bevilacqua, A. M. Niknejad, “An Ultra Wideband CMOS Low-Noise Amplifier for 3.1-10.6 GHz Wireless Receiver”, IEEE Journal of Solid-State Circuits, vol. 39, no. 12, 2004.
[6] F. Bruccoleri, E.A.M. Klumperink, B. Nauta, “Wide-Band CMOS Low Noise Amplifier Exploiting Thermal Noise Cancelling”, IEEE Journal of Solid State Circuits, vol. 39, pp. 275- 282, 2004.
[7] F. Bruccoleri, E.A.M. Klumperink, B. Nauta, “Wideband Low Noise Amplifiers Exploiting Thermal Noise Cancellation”, Dordrecht, The Netherlands: Springer, 2005.
[8] C.-F. Liao, S.I. Liu, “A broadband noise-cancelling MOS LNA for 3.1–10.6-GHz UWB receiver”, IEEE J. Solid-State Circuits, vol. 42, no. 2, pp. 329-339, 2007.
[9] W.H. Chen, G. Liu, B. Zdravko, A.M. Niknejad, A highly linear broadband CMOS LNA employing noise and distortion cancellation.In IEEE Radio Freq. Integrated Circuits Symp. Dig., 2007, pp. 61-64.
[10] S.C. Blaakmeer, E.A.M. Klumperink, D.M.W. Leenaerts, B. Nauta, “Wideband balun- LNA with simultaneous output balancing, noise-canceling and distortion-canceling”, IEEE J. Solid-State Circuits, vol. 43, no. 6, pp. 1341–1350, 2008.
[11] X. Chen, J. Silva-Martinez, S. Hoyos, A CMOS Differential Noise Cancelling Low Noise Transconductance Amplifier. In IEEE Dallas, Circuits and Systems Workshop, 2008, pp. 1-4.
[12] J. Shim, T. Yang, J. Jeong, “Design of low power CMOS ultra wide band low noise amplifier using noise canceling technique”, Elsevier, Microelectronics Journal, vol. 44, pp. 821–826, 2013.
[13] J. Jussila, P. Sivonen, “A 1.2-V highly linear balanced noise-cancelling LNA in 0.13-μm CMOS”, IEEE Journal Solid-State Circuits, vol. 43, no. 3, pp. 579–587, 2008.
[14] S.C. Blaakmeer, E.A.M. Klumperink, D.M.W. Leenaerts, and B. Nauta, A wideband noise-canceling CMOS LNA exploiting a transformer. In IEEE RFIC Symp. Dig. Papers, Jun. 2006, pp. 137–140.
[15] C.-W. Kim et al, “An Ultra-Wideband CMOS Low Noise Amplifier for 3–5-GHz UWB System”, IEEE Journal Solid-State Circuits, vol. 40, no. 2, pp. 544–547, 2005.
[16] H. Rastegar, A. Hakimi, “A High linearity CMOS low noise amplifier for 3.66 GHz applications using current-reused topology”, Elsevier, Microelectronics Journal, vol. 44, pp. 301–306, 2013.
[17] M. Khurram, S.M.R. Hasan, “Novel analysis and optimization of gm-boosted common-gate UWB LNA”, Elsevier, Microelectronics Journal, vol. 42, pp. 253–264, 2011.
[18] S. Toofan, A.R. Rahmati, A. Abrishamifar, G. Roientan Lahiji, “Low power and high gain current reuse LNA with modified input matching and inter-stage inductors”, Elsevier, Microelectronics Journal, vol. 39, pp. 1534–1537, 2008.
[19] S. Toofan, A.R. Rahmati, A. Abrishamifar, G. Roientan Lahiji, “A low-power and high-gain fully-integrated CMOS LNA”, Elsevier, Microelectronics Journal, vol. 38, No. 12, pp. 1150–1155, 2007.
[20] R. Bisht, S. Qureshi, “Design of low-power reconfigurable low-noise amplifier with enhanced linearity”, In IEEE Region10 Conference, 2019, pp. 1216-1219.
[21] T. Han, Zh. Li, M. Tian, An inductor-less CMOS broadband balun gm-boosting LNA exploiting noise cancellation techniques. Analog Integrated Circuits and Signal Processing, vol. 104, pp. 121-129, 2020.

[22] J. Chaghaei, A. Jalali, J. Mazloum, “An inductorless differential LNA with active and passive enhancement for cognitive radio”, Tabriz Journal of Electrical Engineering, pp. 75-85, 2020.

[23] A. Ataeifard K. Monfaredi S. Hossinzadeh. Design and simulation of digitally tuned class C voltage controlled oscillator with enhanced phase noise characteristics. Tabriz Journal of Electrical Engineering, vol. 48, pp. 815-823, 2018.

[24] Y. Lu, K.S. Yeo, A. Cabuk, J. Ma, M.A. Do, Z. Lu, “A novel CMOS low-noise amplifier design for 3.1-to-10.6-GHz ultra-wideband wireless receiver”, IEEE Trans. Circuits Systems, vol. 53, no. 8, pp. 1683 -1692, 2006.

[25] M. Anwar, S. Azeemuddin, M.Z.A. Khan, “Design and Analysis of a Novel Noise Cancelling Topology for Common Gate UWB LNAs VDAT 2013”, Springer CCIS, vol. 382, pp. 169-176, 2013.
[26] T.H. Lee, “The Design of CMOS Radio-Frequency Integrated Circuits”, Cambridge Univ. Press, Second Edition, 2004.
[27] S.C. Blaakmeer, E.A.M. Klumperink, D.M.W. Leenaerts, B. Nauta, A wideband noise-canceling CMOS LNA exploiting a transformer. IEEE RFIC Symp. Dig. Papers, Jun. 2006, pp. 137–140.